Makinex JHT-U Use and Care Manual download pdf (Page 2)

Revision 1 10/04/15

Tool Inspection Process:

Step

Action

Visually check for dents as well as broken, missing or worn parts.

Check to ensure all bolts are secure and tighten or replace them if necessary.

Check the cart angle release cable, ensuring no kinks are present. Adjust or replace if needed.

Check electrical cables on hammer/breaker for damage. Carry out ‘Test and Tag’ procedure on electrical components as required.

Tool Cleaning & Maintenance Process:

Step

Action

If needed, adjust cart angle release cable by tightening the retaining screw, then the adjustment screw

with a Phillips head screw-driver.

Use compressed air to blow off excess dirt / dust.

Place a couple drops of light oil at the top of the release cable so that it runs through the cable housing.

Do not use grease or heavy oil, as this will clog the housing.

Using a grease gun, apply grease via the grease nipple shown in (A) until excess starts to leak.

Wipe off Wipe off tool with clean dry rag

JACK HAMMER TROLLEY

MAINTENANCE GUIDE

Supplier Support #: US Only: 407-446-1966,

407-826-0000

Supplier Website: www.makinexusa.com

PURPOSE

 Follow the directions below to ensure that the Jack Hammer Trolley is in working order and

properly maintained.

SAFETY

 Always wear approved eye and ear protection when working with air tools.

 NEVER operate the machine if parts are faulty.

(A)

1 2

No comments

Makinex JHT-U Use and Care Manual Page 2